Matters needing attention in the use of rubber track
Before installing the crawler, you must check whether the main dimensions of the crawler's width, pitch, length, inner and outer rail widths match the main engine weight, chassis size, wheel train size and other parameters. Mismatch will cause serious damage or breakage of the crawler.
Keep a certain tension (H=10-15mm) when the crawler is in use. If the tension is too small, the phenomenon of wheel slippage and tooth riding will occur, causing scratches on the inner side of the crawler, and even breakage of the crawler. If the tension is too large, the crawler will elongate, causing abnormal wear of the core iron and driving wheel, and even causing the core iron. Broken, the track breaks.
It is forbidden to forcibly climb the steps, or walk on the edge of the steps by friction. This will cause damage to the track.
Production and preparation of low-temperature SCR denitration catalyst.
It is forbidden to drive on steep slopes or make sharp turns while walking. This will cause the wheels to fall off, damage the track, and even cause the machine to tip over.
It is forbidden to go straight down the high steps. This will cause the track core iron to fall off and the steel wire to break.
It is forbidden to walk on undulating and uneven roads. It is easy to cause wheel breakage, which will cause damage to the track pattern and breakage of the core iron.
In the environment of chemicals, engine oil, sea water, etc., the rubber will accelerate the aging. The crawler should be cleaned after use in these environments. Long-term use will reduce the life of the crawler.
Avoid walking on gravel, gravel, steel, and stone roads. It will cause cracking and damage to the track grounding surface.
It is forbidden for the track to land on one side. It will cause damage to the track pattern and break the core iron.
It is forbidden to walk across the bridge. It is easy to cause wheel breakage, which will cause damage to the track pattern and breakage of the core iron.
Overload operation is prohibited. It will increase the tension of the track, accelerate the wear of the core iron, and cause the core iron to break and the track to break in severe cases.
When the crawler is not used for a long time, clean the dirt and oil on the crawler with water, and avoid direct sunlight and rain after drying; when the crawler is not used for a long time, the crawler should be adjusted and relaxed to avoid fatigue.