Crawler shoes are like shoes that people wear. During the process of equipment walking, as a component that is in direct contact with the ground, the unevenness of the road surface and small materials will cause wear and tear. Therefore, the quality of the ATV track parts shoes is very important. Turn the chain link to the middle height of both ends and knock it out. At this time, the crawler shoe can be placed flat and in a line shape, and the excavator walks on one side to the top of the crawler. At this time, we need an iron bar to "guide" the track shoes to the "right track". Assemble from the drive wheel, place the iron bar under the crawler shoe, and prop up the machine to rotate the crawler.

At this time, a person is required to operate and walk in the cab, while lifting the crawler while turning the crawler forward, passing the upper supporting wheel, walking to The position of the guide wheel, at this time, an object can be placed at the guide wheel, then the two sides of the track are butted, and the live pin shaft can be assembled. This method is also suitable for rubber track assembly. Due to the aging of live pins, it is difficult to beat, and even requires welding and cutting equipment to assemble. Therefore, this method is generally not recommended.

When one side of the crawler is falling off, to clean the debris around the crawler, the drive wheel must be docked first, the upper crawler should be hooked up with a bucket, and the drive wheel should be aligned and entered into the crawler. , and align the upper tug, this step is one-third complete. The crawler chain plate often falls off in the work of excavators, especially for machines that have been used for a long time. Operators with insufficient operating experience often have no countermeasures.

So how to assemble the chain after the chain falls off? How to reduce or Is it possible to avoid this phenomenon to a certain extent? Support the machine to walk on one side to make the track straight, support the machine again and get off the car to adjust the lower track, try to make the track fall and the rollers are aligned with the track. At this point, three steps have been completed. two-thirds. Just use the bucket to gently lift the excavator and use the bucket teeth to hook up the crawler, so that the guide wheel enters the crawler. Then, adjust the crawler to align with the guide wheel, then turn the crawler and add butter. At this time, the crawler has been assembled.